View source for Device Solves

=FLOODS Specific Commands=

*[[Initial Guess]] - start the numerical solve off well
*[[Contact Command | contact]] - define contacts physically, and define contact physics
*[[Device Command | device]] - bias contacts and solve steady-state or transient


=Small-signal analysis=
*[[Sinusoidal Steady State Analysis]]
Sinusoidal Steady State Analysis is typically used to carry out small-signal analysis for extracting capacitance, transconductance, current-gain and  cut-off frequencies. Even without energy  balance/hydrodynamic model, accurate results can be obtained up to several GHz.
Consider the symbolic representation of the 3 device equations: Poisson, electron and hole continuity equations.

[[File:Dev_eqn.png|200px]]

The dot term represents the time derivative component of the electron and hole electron continuity equations.
Sinusoidal Steady State Analysis (S3A) solves the device equation system in the frequency domain as a steady state perturbed by an infinitesimal signal. The small signal assumption allows linearization of the device around the DC bias point. The corresponding Jacobian takes the symbolic form: 

[[File:matrix.png|300px]]

which is a 3Nx3N matrix (for 3 solution variables and N nodes). Notice the imaginary frequency dependent components in the electron and hole rows corresponding to the time derivative dot term in the continuity equation. 
The matrix equation now takes a form slightly different to the steady-state form JX=B.

[[File:matrix_eqn.png|130px]]

where J remains the steady-state Jacobian at the desired DC-bias point, D is now a diagonal matrix with zeros for Poisson rows and ω=2πf for diagonal elements of continuity rows. Both are 3Nx3N matrices. X is solution vector and B is boundary condition vector.
For computational reasons(i.e. seperating real and imaginary terms), the matrix system takes the following 6Nx6N form

[[File:final_matrix_eqn.png|200px]] 

where XR and XI are real and imaginary components of the solution variables.

==== Examples ====
 device
 contact name=VSS voltage supply=1.0 acreal
 contact name=VSS voltage supply=0.0 acimag 
 device freq=100

First device does a steady-state solution at previously provided bias point.
Setting "real" supply to unity would be recommended as response is linear (also convenient for obtaining conductance directly from current). 
Small-signal of 100 Hz is applied at the chosen contact. 

For a highly doped resistor, consider just electron current.

 set Re_cur ([contact name=VSS sol=Elec flux acreal])]
 set Im_cur ([contact name=VSS sol=Elec flux acimag])]

As expected for low resistance, real current Re_cur will be high and imaginary current Im_cur due to capacitive component will be extremely low.